240710 ハンディファン再考・DSS
ハンディファン
僕は使って無いんだけど
隣で恩恵に与って居る
女史たちを視て
このモーター音は
何とかナらんだろうか
と
考えてみる事にシた
は、ハンディファンだからね！
ゼンマイは金属製がイイな
何よりモチがイイ
おっ！
SPRON100なる素材を発見
https://m.sii.co.jp/jp/me/spron/products/spron100/
金属製だから
相応の重さが有ると踏んで
本体下部に配置した
重心が下に在れば
立て易いし倒れ難い
更に小さく造れれば
胸のポケットに挿したまま使える
コンプレッサーか
小さなファンの
回転数を安定サせる為に
脱進機を配置シたい
もちろん腕時計の様な
モノで無くて好いはず
極端に減速スると…( ･_･)！
善いのか！
その分ギア比を低くシて
沢山回せば善いのか
吸入口の直ぐ上に
ファンが在ればイイかな
鹿威しの様な先端で
縁から風を細く出して
周りの空気を連れて行く
ダイソンのソレに似てるなぁ
本体を雑巾絞りの様に
ツイストする事で
ゼンマイを巻き上げ
継ぎ目を
伸ばすか縮めるかで
オン・オフ
240710 Handy Fan Ideas, DSS
Handy Fan
I don't use it.
I don't use it, but look at the girls next to me who benefit from it.
I wonder if they can do something about the motor noise
I decided to think about it.
is a handy fan, right?
I prefer a metal spring.
More importantly, it's easier to work with.
Oops!
I found a material called SPRON100!
https://m.sii.co.jp/jp/me/spron/products/spron100/
Micro Energy Division, Seiko Instruments Inc.
Official WEB site of Seiko Instruments Inc.
m.sii.co.jp
Because it is made of metal
I thought it would have a reasonable weight.
We placed it at the bottom of the main body.
If the center of gravity is at the bottom
it is easy to stand and hard to fall over.
If we can make it even smaller...
I can use it while it's in my breast pocket.
A compressor or a small fan
I'd like to put an escapement to stabilize the rotation speed
Of course, it doesn't have to be like a wristwatch.
If we slow it down too much...(...)
Is it good?
Is it good if we use a lower gear ratio and rotate it a lot?
Would it be better if there was a fan right above the intake?
With a tip like a deerstalker
With a thin stream of air coming out of the rim
And take the air around it with it.
It's like a Dyson.
By twisting the body like a rag squeeze
Winds up the spring
By stretching or shrinking the joints
on or off
by DeepL
この記事が気に入ったらチップで応援してみませんか？