Hp Printer 79 Service Error-[Complete Guide]

The Hp Printer 79 Service Error is a vital hardware error. There may be many reasons causing this error such as issues with the network cable, printer driver, motherboard, network or EIO card, firmware DIMMs, etc. This error can be resolved by either If you are facing the same issue, then no need to worry about it. You can resolve this issue by following certain steps recommended by HP LaserJet Printer Technical Support. Follow the steps to Resolve Hp Printer 79 Service Error.

There are 3 main reasons behind Hp Printer Service Error 79:

The first reason is when your network is shared by too many devices.
When your router needs a rest, it can cause connectivity issues.
Sometimes stuck print ques can result in this error.

Methods to Fix Hp Printer 79 Service Error:

Method 1: Unplug the power cable
You need to make sure that HP LaserJet Printer 3050 is installed properly. Sometimes disconnecting the power source may solve this error. You have to unplug the power cable to apply this method. Follow the steps mentioned below to proceed:
Disconnect the HP LaserJet Printer 3050 Power cable
Wait for at least 2 to 3 minutes
Connect your power cable again
Check if the error is resolved. In case if the error persists, you can try using the next method.

Method 2: Perform other tasks:
Step 1: Network replacement
Replace your network cable and the cycle power
Step 2: Removal of Network
Try removing the network and the cycle power
Step 3: Remove the DIMMs of the Printer
Try removing DIMMs for once and the cycle power
Step 4: Test the motherboard of the printer
To test the motherboard, you will have to print by using a parallel interface through a parallel cable.
Step 5: Cold reset
When the network is removed, perform a Cold Reset in the printer
Step 6: Now replace the Network or EIO Card
When the network cable is removed and the problem persists, try replacing the Network or EIO Card
Step 7: Replace the DIMMs Firmware of the printer
Next, you will have to act on replacing the DIMMs Firmware
Step 8: Try replacing Formatter Board
If the error still exists, users can replace the Formatter Board of the Printer

Method 3: To fix Hp Printer 79 Service Error, Update the Drivers of HP LaserJet Printer.
Often the old drivers in HP LaserJet Printers may cause difficulties. Therefore it is important to update the printer drivers on time.
The above-mentioned methods will surely help in troubleshooting this error. If you still find this error in your HP LaserJet Printer 3050, then you will be required professional help.

Follow mentioned Blog for expert Help.